DIY Curtain Rods
So, we finished our home office um.........6 months ago and I have yet to show you all the final results. Bad blogger, bad. I know...But I'm back today to redeem myself. Before I show you the fully finished space I want to tell you about one area we DIY'ed wayyy back at the beginning. The curtain rod. Before we painted the ceiling, stenciled the floor or even decided to turn the sunroom into a home office we had curtains on the brain.
There are windows on the entire left wall of the room in addition to the back wall with glass doors that go out onto the back deck. Our concept was to install a curtain rod that would run along both of these walls so we could install curtain panels to cover all windows should we ever choose to. In general, we wanted to keep costs low on this project and we realized this may be difficult given the custom sizing and orientation of the rod, so we decided to try and tackle it DIY style.
We found some cool stair rail supports at Home Depot and decided these would work perfectly to hold the rod. We bought 6 and installed them spaced out above the windows.
For the rod itself we bought a piece of rounded trim that Brent mitered for the turns.
And then stained with a warm Ash stain.
Once the stain had dried on the rods they promptly went into the yellow room (junk room/
soon to be nursery) where they were stored until 6 months ago when the office was finishing up. Obviously this was not the plan initially; we had actually picked up four
white curtain panels from Ikea when we were gathering the rest of the supplies for the project. But by the time the hardware was installed and the rod was stained we had decided to tackle the floors, and hanging the drapes PRE stenciling those floors seemed like the worst idea ever. Especially since the curtains are stark white. So we stored those bad boys too.
Fast forward give or take a year and a half and the desks were installed, which meant the curtains along the window wall had to be custom chopped (courtesy of our in-family-seamstress Cindy) and up they went!
The new desk cabinets (yet to be revealed) run along the window wall so the three panels on this wall were cut to rest atop the wood countertops.
We were however able to keep the panel to the right of the glass doors full length which frames out this wall nicely. We really liked/like the look of the stair rail mount holding the wooden rod, but because the rod is screwed to the actual mount getting the curtains on the rod took a bit of finagling, but it was well worth it.
It's super fun to sit back and appreciate a project so long in the making. The curtain rods + curtains are only one small part of the big picture of this space, but we are really happy with how they turned out. Full reveal coming soon. PROMISE!